SWC Forums

Pull up a chair...let's talk fishing.

Dual batteries
 
Notifications
Clear all

Dual batteries

20 Posts
11 Users
0 Reactions
71.4 K Views
J.T.
 J.T.
(@)
Active Member
Joined: 14 years ago
Posts: 10
Topic starter   [#43422]

Need some clarification on dual batteries. My understanding is cranking battery for obviously starting engine and deep cycle best for electronics, I.e. Bottom fishing with motor off and instruments on. I didn't much pay attention to what I had when I bought my boat but now see its two crank batteries. I was in need of a new battery in a fix the other day and purchased a deep cycle.

So, OK to have one of each? Two deep cycles if I replace the other one?

Also have read differing opinions on running switch on 1, 2, or both. My dealer told me to run on both. Thoughts and thanks for advise.



   
Quote
Buck Buchanan
(@)
Reputable Member
Joined: 12 years ago
Posts: 274
 

Most batteries in a dual setup are cranking



   
ReplyQuote
David Plowden
(@mealonreels)
Prominent Member
Joined: 16 years ago
Posts: 652
 

The starting battery should be #1 and the battery switch should stay on #1.The house battery(electronics& accessories) is #2 and is kept charged with a voltage sensing relay.This way nothing is drawing off the starting battery and it stays charged.It's not good to run battery switch on both.Both batteries could be discharged and not start engine.Also if one battery has a dead cell it would pull the other battery down with it.With a VSR the batteries are isolated.



   
ReplyQuote
Bob Mason
(@atbob)
Estimable Member
Joined: 15 years ago
Posts: 156
 

Only way you should ever run the switch in "BOTH" is with identical batteries, purchased at the same time and used identically.
Don't ask how I've learned this, over and over.



   
ReplyQuote
Wes Hudson
(@reznor)
Reputable Member
Joined: 16 years ago
Posts: 441
 

Ok, so do you start on battery 1, and then switch to "2" at some point? Or just leave on "1" all day?

Thanks



   
ReplyQuote
Bob Mason
(@atbob)
Estimable Member
Joined: 15 years ago
Posts: 156
 

I always use the "BOTH" setting.



   
ReplyQuote
Alan Lea
(@)
Trusted Member
Joined: 15 years ago
Posts: 52
 

Check out this video link below. Does anyone have any experience with the Blue Sea Battery System?

www.youtube.com/watch?v=B4830QsybbM



   
ReplyQuote
Randy Hoffman
(@)
Estimable Member
Joined: 13 years ago
Posts: 192
 

I always use the "BOTH" setting.

Not good practice. If your charging system had ever failed and you weren't watching your gauge, when your motor quit both batteries would have been dead and you would have been adrift with no radio. If you had kill just one, at least you would have had the other battery to hail for assistance and get you some distance toward port or at least to where you could safely drop anchor.



   
ReplyQuote
Rick Davis
(@)
Estimable Member
Joined: 14 years ago
Posts: 106
 

After today I will be getting a dual battery system.

Only have a single battery system and today my engine would not start - 5 hrs of 2 livewells, fishfinder and stereo did me in. Luckily the radio island boat ramp was down current and down wind of me. Riptide to the rescue - it got me to the dock so I could borrow a jump start box. Got it refired and motored back to Airport boat ramp. Short term and as a back up I will be getting a jump start pack - long term, dual batteries!



   
ReplyQuote
Bob Mason
(@atbob)
Estimable Member
Joined: 15 years ago
Posts: 156
 

intubaited: So you would recommend using one or the other. For a while I was using odd/even to match the day of the month.
I do see your point, but don't like getting a power down on the GPS when I start the engine. Just a nuscense, but better than calling TowBoat.



   
ReplyQuote
David Plowden
(@mealonreels)
Prominent Member
Joined: 16 years ago
Posts: 652
 

Battery switch stays on #1(starting battery)...House battery(electronics&accessories)is #2 and charged with voltage sensing relay.This relay simply connects between #1 & #2 post on battery switch.This way there is no voltage drop on gps/fishfinder when starting engine and nothing drawing voltage from starting battery



   
ReplyQuote
Bobby MacQueen
(@angermanagement)
Estimable Member
Joined: 12 years ago
Posts: 171
 

I am running the setup above, Starting(1) + house(2), but start on the starting battery (1) and switch to (2) after a few minutes and the battery has recharged. Is there a problem with this?

From how I'm taking your post I should be installing a VSR like this? And run it on (1) always.. what are the benefits of this compared? Just not having to switch the perko switch?

http://www.westmarine.com/buy/marinco--digital-voltage-sensing-relay-dvsr-12-24v--14152185



   
ReplyQuote
Randy Hoffman
(@)
Estimable Member
Joined: 13 years ago
Posts: 192
 

intubaited: So you would recommend using one or the other. For a while I was using odd/even to match the day of the month.
I do see your point, but don't like getting a power down on the GPS when I start the engine. Just a nuscense, but better than calling TowBoat.

Sorry for this lengthy response, but you'll get a bunch of opinions on "the best" way to manage multiple batteries and I don't have that. I have one step above a single battery which is dual batteries on a switch and system that works for me. I run both deep cycle starting batteries and generally always have them both fully charged before I leave the dock. I'll use one for starting and running and the other for when the motor is off. If I don't cut the motor off, the second one may not get used at all.

Just about the only variation to that would be if I pull up anchor to make a decent run and want to put some charge back in the one I was anchored on. I have a single outboard and they really don't significantly charge a battery underway so I wouldn't run with anything else drawing power that wasn't absolutely necessary. I have been known to run on "both" in that situation to charge the one I was drawing off of while it also borrows juice from the starting battery. I hope that all makes sense.



   
ReplyQuote
David Plowden
(@mealonreels)
Prominent Member
Joined: 16 years ago
Posts: 652
 

Anger M ..Your way would work fine.For me,there is a lot of starting and stopping so to much switching and remembering to switch.Yes,that vsr would work.



   
ReplyQuote
JOHN K HESS
(@safelanding)
Trusted Member
Joined: 15 years ago
Posts: 62
 

Here is a good read , it s called solving the battery switch dilemma. http://www.boattest.com/Resources/view_news.aspx?NewsID=3084



   
ReplyQuote
Page 1 / 2
Share: