SWC Forums

Pull up a chair...let's talk fishing.

Offshore Boat
 
Notifications
Clear all

Offshore Boat

34 Posts
23 Users
0 Reactions
76.2 K Views
Paul Schaeffer
(@)
Reputable Member
Joined: 12 years ago
Posts: 215
Topic starter   [#44191]

Last year I bought my 21 deep v cc, now I want a bigger boat. Im curious to know what everyone looks for when they start looking for a offshore boat. I was thinking 24'-26' but unsure if I want twins or singles. Anyone have a boat that size with a single? If you do, do you have any performance numbers on it?

Also anyone have any pros and cons to going with twins vs single outboard? Other then if a motor dies you could limp back on one.



   
Quote
(@capt_dave)
Member Admin Registered
Joined: 3 years ago
Posts: 12511
 

We are talking offshore boats here....

It is all in the hull design.

I look for good fair at the bow. You want something that will not only split the sea but also give good lift before it goes under. This will also help with throwing water up in to the air (Getting you wet). You want gunnels that are high enough not to flip you out of the boat. Just higher than knees is as short as you want. I like a wider beam and a flatter stern. A V that goes all the way to the back of the boat will troll well and track well but will roll side to side alot. I like a heavy V up front coming back to fairly flat and wide at the back.

Motors...Always 2. I know people that do singles....I want 2...end of story. Too many things can and do happen. If 1 breaks you have another one. It makes handling them MUCH easier.

Just my .02!

Dave



   
ReplyQuote
Bill Jolly
(@barnaclebill)
Honorable Member
Joined: 20 years ago
Posts: 468
 

Everything Capt. Dave said. I had always run a single engine but after owning duals I'll never go back. I'm not so worried about dependable although that's a plus but maneuverability is the thing. Being able to steer with just the engines is awesome.



   
ReplyQuote
Paul Schaeffer
(@)
Reputable Member
Joined: 12 years ago
Posts: 215
Topic starter  

Thank you both. When I see the degree of dead rise a 24 degree will ride better then say 18 degrees correct?



   
ReplyQuote
Kevin
(@bodie)
Noble Member
Joined: 21 years ago
Posts: 1795
 

yes 24 is deeper and will ride better, but will roll more. for an offshore boat with long runs i would have 24 no question



   
ReplyQuote
Rodney
(@rkforte)
Noble Member
Joined: 14 years ago
Posts: 1072
 

When talking deadrise you have three section of your boat entry , midship. and transom. You want a big entry say 60 degree and get flatter as you go back. Like Capt Dave said. An 18 degree trasom deadrise will be very stable when bottom fishing were as a 24 will rock a little.



   
ReplyQuote
Barry Turano
(@barryturano)
Famed Member
Joined: 17 years ago
Posts: 2720
 

I have a 24 Albemarle cc, 24 degree deadrise bow to stern great ride will eat up a head sea. But as noted she will roll a little on anchor or drift. But I would not sacrifice the ride for the roll. My motor (to my thinking is a little small) 5.0 250 hp inboard with a jackshaft and duoprop drive. I cruise at 25mph and burn about 2 gph. If and when I re-power I would go to a 5.7 315 hp.



   
ReplyQuote
Rodney
(@rkforte)
Noble Member
Joined: 14 years ago
Posts: 1072
 

My friend had a 24 Albemarle CC and loved it. He rarely bottom fished though.



   
ReplyQuote
Nathan
(@ntbrinkl)
Reputable Member
Joined: 13 years ago
Posts: 216
 

Went out the weekend may 25th. Got about a mile shy of 90ft drop and had an oil pump crack bad on one of the motors. Dumped just about all the oil and did it fast. Went ahead turned the boat around and put the rods in. Lucky enough the seas were fairly calm and we hooked up with a few mahi on the way in.



   
ReplyQuote
jarte
(@)
Eminent Member
Joined: 22 years ago
Posts: 21
 

Im not a 25 degree at the transome guy. my boat is 26ft the entry is good enough wish it was more. Got to have the twin engines. mine are mounted on 30inch centers and the dam thing handles great. There are always trade offs but the people that get there 15 or 20 minutes before me alot of time dont have the all day good stable fishing platform I do. By the way at the transome Im 20 degrees.



   
ReplyQuote
Jamie Blue
(@)
Famed Member
Joined: 20 years ago
Posts: 3660
 

My next boat will be a cat.

In your size range look at the prowler 24.



   
ReplyQuote
Frank Smith
(@wildcard)
Noble Member
Joined: 17 years ago
Posts: 1573
 

Capt Dave, you sound like you're describing a Keith Willis 25 Down easter. I have one with a pair of 130 Honda's, drop the tabs and it'll plane out on one engine. A no fluff boat, but an all fish boat, on the troll or bottom fishing.



   
ReplyQuote
Rich
 Rich
(@squid-row)
Illustrious Member
Joined: 22 years ago
Posts: 4097
 

There is no replacement for displacement



   
ReplyQuote
john Smith
(@)
Noble Member
Joined: 18 years ago
Posts: 1776
 

Go straight to the top....

http://www.onslowbayboats.com/27xs.html

Carolina Flare for a dry, safe ride. True deep V for
a soft ride and a NC design/build 3 piece hull
for fishability.



   
ReplyQuote
steve brewer
(@)
Noble Member
Joined: 17 years ago
Posts: 1094
 

My next boat will be a cat.

In your size range look at the prowler 24.

I have a prowler 24 and its a great boat. They are hard to find, expensive, but tough as hell and more storage room than any CC out there. If you ever want to ride on one let me know. Out of Holden Beach.

There are a lot of great mono hulls out there too. Both have pros and cons. If you bottom fish more I would go with a cat. If you troll, my personal opinion is that a mono hull is better suited for trolling. I would go with two motors if possible but it adds a lot of expense in upkeep for two. LWR has a nice 24 seafox for sale on this site with a single and has caught just about everything in the ocean in that boat.

Good luck with whatever you pick.



   
ReplyQuote
Page 1 / 3
Share: