SWC Forums
Pull up a chair...let's talk fishing.
I lost some bigger fish recently and think its due to my knots....
What type of knot is used for braid to swivel?
30 pound mono to swivel / hook?
80 pound mono to swivel/hook?
Braid to mono?
When do you bring out the crimper? Single sleeve or double?
Never had many knot failures before, but have not been fishing for biguns on the bottom mich either.
Thanks guys.
"What type of knot is used for braid to swivel?"
Uni ... maybe throw in a palomar once in a while.
"30 pound mono to swivel / hook?"
Uni
"80 pound mono to swivel/hook?"
Anything over 50 I use a crimp
"Braid to mono?"
Uni Uni
"When do you bring out the crimper? Single sleeve or double?"
Anything over 50 mono ... Always double
That is exactly what i am already doing... Except for palomar. Lost several sheephead, big ones, at the knot. Also lost some big bottom creatures too, not sure if the knot was an issue.
Thanks for sharing
rapala knot should hold it
When tying braid to a swivel, use a palomar knot. The trick is to put fishing glue on the knot, Berkley makes it, and let it dry. This keeps the braid from "slipping" which is what you are probably experienceing. Also be sure to use quality swivels -the weak link factor coming into play. Hope this helps!!!
How long for the glue to dry? Can you tie knot at sea and get back in water swiftly?
the palomar knots I have been experimenting with on my 50 lb braid while in my garage this week, were ALL breaking about 1/2 to 3/4" above the knot. I wet them all, and I'm sure I wasn't pulling 50 lbs on it...
🙁
Stew
I second everything said above, but for braid to mono, I use a sebile knot. It takes a little while to tie, but runs through the guides easily and I have not had one break yet.
It only takes a few minutes at most for the glue to dry. It's kinda like super glue but with different chemical properties as regular super glue has been known to affect the integrity of braided line. I'll put it like this, I've not had a knot break or slip yet using this method and thats fighting some big fish. Give it a try and you will agree.
be careful sometimes you can buy new braid be rotten just sitting on shelf to long
Just my opinion ... but you shouldn't need to glue to get your knots to hold.
I always use the uni when under 50# line, never had one break. I broke a couple of good hooks testing connections in my garage. There are some good vids on YouTube that will show in great detail how to correctly make these connections.
Braid to swivel-surgeon loop, bimini or spider hitch to form the loop. Then offshore swivel knot to the swivel.
Anytime I tie mono to the hook or swivel 80lb and under I use a 4-5 turn uni.
Above 80lb I use a crimp.
To form a loop when providing something for a coastloc to snap on, I use a crimp from 60lb and over.
Braid to mono again one of the loops mentioned above. Then a no name knot to tie the mono in.
Double barrel sleeve for 400lb and under. Single Alum sleeve for above 400 lb.
Never had a failure with any of the above. I do re tie all my knots before every trip out.
mono knots for 50 lb and under = uni.
Braid knots to swivels = palomar
braid to mono = albright, and i might tie it a couple times til i get one i like
Braid to swivel, go through the swivel twice, at leat 6 turn uni, make sure the wraps bed down right, if not re-tie
Broke a rod before the knot.