SWC Forums

Pull up a chair...let's talk fishing.

Notifications
Clear all

WB Kings

5 Posts
2 Users
0 Reactions
813 Views
Barry Bierstedt
(@)
Prominent Member
Joined: 18 years ago
Posts: 677
Topic starter   [#46164]

Had a good fun and productive day king mackerel fishing with my dad and an old friend Hank. We left CB inlet and looked for pogies all the way up through Wrightsville. We found some but they were in shallow inside the breakers. We decided to head on out 10 miles with our dead cigars. After a slow start we caught alot of nice fish with some double headers. Had 4 fish that weighed 116lbs gutted. Great day on the water. I even got to finally catch a king on my Penn 650ss spinner. Hank got some drone footage that I will post up later.img952766_256.jpgimg952776_110.jpg



   
Quote
Barry Bierstedt
(@)
Prominent Member
Joined: 18 years ago
Posts: 677
Topic starter  

Here is the big fish from today's trip. 42 lb King caught on a dead cigar minnow.img950978a_144.jpg



   
ReplyQuote
Barry Turano
(@barryturano)
Famed Member
Joined: 17 years ago
Posts: 2720
 

Nice to know I was headed in the right direction. Left the dock at 8:15 was due to be at my spot at 8:45. Was a mile away when the motor started bogging down for no reason. decided against taking the chance. So we headed to MBI instead of CB. RPM's were dropping and I did not want to go through CB Inlet with the possibility of low or no RPM's. Every time I would hit a wave she would stumble. In the water way she would surge and fall. Got back to the dock and left it alone. Today I met the mechanic at the boat found that the wire from the coil to the distributor was barely attached. Fixed that with a zip tie to make sure it does not loosen. Took off the 10 micron FWS no water but brown crud at the bottom of the jar. Went and pulled the carb filter screen, more brown crap. My FWS is a small cartridge (maybe 1/2 pint) put a new FWS cartridge. Everything is good to go now. Boat is running fine. To bad it was a day late. I am going to add a large capacity FWS up stream of the current FWS. I was looking to use a 10 micron on the upstream and a 2 micron on the one on the motor. Found out that they only make 10 micron filters that will fit the motor. Hopefully using 2 FWS filters will help.

Any way real nice fish :wtg:



   
ReplyQuote
Barry Bierstedt
(@)
Prominent Member
Joined: 18 years ago
Posts: 677
Topic starter  

Hopefully they will still be in close after this next cold snap and blow.



   
ReplyQuote
Barry Turano
(@barryturano)
Famed Member
Joined: 17 years ago
Posts: 2720
 

CAPT_ B

Please accept my apology it was not my intention to "hijack" your thread. I just started writing and off the rails it went. Sorry.

I'm happy that you had a great trip. I'm also a little envious.
Barry



   
ReplyQuote
Share: