SWC Forums
Pull up a chair...let's talk fishing.
Hey guys, i have a wesco trailer that seems sits really high at the tongue and requires alot of rise on the hitch to ride level. Its a tandem axle trailer, and if you measure the bottom of the frame just in front of the front wheel and behind the back they both sit at 16.5 inches...BUT when they are level, the tongue sits at 22 inches, so I guess they built a bend into it for the boat, but since the coupler sits on top of the frame that puts it up even higher. With a 4 inch rise its the closest i can get it to level. The jack barely raises that high so i have to put a block under it to hook up...
Do they normally build these trailers this way or is this something out of the ordinary? Any suggestions?
It all depends on your truck not the trailer my truck sits high so I use a 2” drop but I have always used a block under the jack plate.
It’s a newer z71 1500 and they already sit a little high I think, I’ll get a picture
I think i am pulling the same boat and trailer you are, sea hunt 234 wesco tandem axle, i use a 2" drop behind a GMC Yukon. Dont really have a problem but i do use ablock under the jack.
Is that a 70e coupler? Is so it looks pinched up..
Stock hitch? The receiver center appears substantially below the level of the bumper. The trailer coupler, oddly enough is back at bumper level. Most of your offset up is overcoming the low level of the receiver hitch tube.
For my 2011 RAM, I use 2" drop trailer hitch flipped up. It works great. However, if I let my tailgate down, it will hit the top of the coupler. I just make sure I have something like a rolled up towel to rest the bed on the coupler. I still have to use a wood block to get the trailer off the hitch when I get back home. Wesco Trailer with GameFish 25
well after hearing from you all maybe I am not crazy, I'll get it checked out at the next service then...either way its done fine on two trips to the coast since then...


