SWC Forums

Pull up a chair...let's talk fishing.

Yamaha 250 HPDI not...
 
Notifications
Clear all

Yamaha 250 HPDI not going full throttle

5 Posts
4 Users
0 Reactions
6,476 Views
Paul Rudar
(@surffishn)
Reputable Member
Joined: 16 years ago
Posts: 262
Topic starter   [#58018]

I had water in fuel always use non ethanol. But boat sat for awhile. Before launching I did service. Plugs,lower unit lube. Racor and visible filters . Got fuel alarm after 20 minutes. cleaned out visibles twice. Third time I cleaned out racors and visible. It Idled great in gear and trolled for a couple hours. But after first alarm port motor only went to 3500 rpm. Other motor ran strong. After trolling and on way to hill . Port still only 3500 starboard 5200. Which is normal for props. My question is there a way to reset Port? Or do I have other problems? Thanks in advance!



   
Quote
David Plowden
(@mealonreels)
Prominent Member
Joined: 16 years ago
Posts: 652
 

The VST filter may need to be changed or an injector may be clogged



   
ReplyQuote
warren barton
(@rockhound)
Noble Member
Joined: 19 years ago
Posts: 946
 

You need to pull mystery filters along with the others.Youre gonna have to go thru the whole fuel system,Be there,Dine that!



   
ReplyQuote
Paul Rudar
(@surffishn)
Reputable Member
Joined: 16 years ago
Posts: 262
Topic starter  

Update ::dumped racor filter. Filled it with seafoam. Ran in tank seemed better. Dumped racor again. Filled with seafoam . Launched and ran it is ok now. Ran over 100 miles to make sure.



   
ReplyQuote
Glen Peterson
(@)
New Member
Joined: 3 years ago
Posts: 1
 

https://sonicexe.io sonic exe

I had water in fuel always use non ethanol. But boat sat for awhile. Before launching I did service. Plugs,lower unit lube. Racor and visible filters . Got fuel alarm after 20 minutes. cleaned out visibles twice. Third time I cleaned out racors and visible. It Idled great in gear and trolled for a couple hours. But after first alarm port motor only went to 3500 rpm. Other motor ran strong. After trolling and on way to hill . Port still only 3500 starboard 5200. Which is normal for props. My question is there a way to reset Port? Or do I have other problems? Thanks in advance!

I think you should clean the fuel injector because it may be clogged causing reduced engine performance.



   
ReplyQuote
Share: