SWC Forums
Pull up a chair...let's talk fishing.
I mostly fish for Kings, dolphin, etc but sometimes troll for Spanish. I've been usng a #2 planer on a.short line and it catches a lot of Spanish but sometimes it will not trip with a 12-13" fish. Last time out I decided to try a #1 Planer since it should trip easier with the smaller fish, but it wouldn't stay down at the 6-8 mph I wanted to troll. Has anybody else had this problem. I'm sure I could drop it back further and that would help but that would mean dropping the other lines way back to avoid tangles.
I pull #1s a lot for spanish, never had a problem as they usually dig in deeper the faster you go. What lure are you pulling behind it? Could it be tripping it?
I usually drop them back for a 3 count or 5 count and set them.
Thanks. I feel sure its not the lure since it's just a small clarkspoon. I've got several #1's so I'll try different ones to see if one will stay down. Might just be the planer i was trying to use. I usually use the #2's but you can miss a lot of fish if it doesn't trip and then you drag a dead fish around for a while. Those little fish won't even bounce the tip so you know one is on.
Make sure the bar on the planer(with the ring on it) isn't bent. If it is tilted one way or the other it won't run straight and will run to one side or the other and maybe up. I use #1's and pull them 5-7 mph and they stay down.
Try the new Clarkspoon planers. They are a better design and have a brass ring instead of stainless. Trip and fish much better.
Make sure you are not in too shallow of water. I have been in 10-15 ft and the planer hit the bottom and tripped. It was right around the sand bar area in front of the Ft Macon Rock Jetty out of Beaufort inlet. Made me think I had a fish on. I actually caught a flounder one time by accidentally hitting the bottom. Caught it on a small 0 silver clarkspoon.
Thanks for the tips. I have a feeling the bar with the ring is out of alignment. I was in such a hurry to change it out I didn't think to check. It would go down a short ways and then shoot to the left and up to the surface, just as you might expect if it's not pulling straight. I have about six of them and I've only tried the #1's twice and either I happened to try the same one both trips or I have two not pulling straight. I'll get it figured out since all you guys are pulling them with no problems.
make sure the lead weight on the planer is not loose