SWC Forums
Pull up a chair...let's talk fishing.
When u say drain the gas I'm assuming u mean all 60 gal I have in the tank ?
Before i drained all 60 gal I would disconnect primer bulb and pump a mason jar full of gas. Let it settle for a couple hours and see what it looks like.
Ethanol gas is definitely inferior to pure gasoline but isn't the death warrant many make it out to be.
Also just to check if I've changed the filter already or not, where is the "vst" filter located
It is inside the VST on the side of the engine. You cannot see it until you remove and disassemble the VST.
Ok so the small clear plastic cylinder that has fuel in it w a small metal screen under the coweling on the same side as the starter...is not the vst then?
Ok so the small clear plastic cylinder that has fuel in it w a small metal screen under the coweling on the same side as the starter...is not the vst then?
No. You might want to have a Yamaha mechanic do the job for you. If the pump has a leak after rebuild(o-ring not seated) it will spray gas at a high pressure which is not a good thing.
Follow the recommended above. You can replace all those filters for less than $100. That's something that every boat owner should know how to do.
If you put fuel with ethanol into your tank, better treat it fast or pump it out. It doesn't take long for it to start making water. I have always used star-tron treatment and never had a problem.
This video might help you understand.
https://www.youtube.com/watch?v=YeCyFxoWPpo
I had to cleanout my jets too. What ever non-ethanol fuel cost, it is worth it.