SWC Forums
Pull up a chair...let's talk fishing.
My motor is a 2006 Mercury 200 Opti that only had 130 hours on it when purchased about 3 years ago. This past week I decided to change out the fuel lines, fuel water separator and the fuel filter on it because it was showing signs of ethanol damage. When I went to the local Mercury shop to get the parts for the job the mechanic advised that this motor does not need a priming bulb. This seemed odd to me, but I trusted his opinion. So based on his advice I did not put a bulb on between the fuel water separator and the engine. I completed the job, topped off the fuel water separator with fuel and also put fuel back into the fuel filter. It fired right up and ran great for about 5 minutes and then stalled out and would not start again. I have re-primed the fuel water separator and the filter and it starts and runs for a few minutes and then stalls out again. Going back and reading this it seems like putting a bulb on would probably fix this problem. I'm looking for some feed back. Am I missing something else or does it just need the bulb despite the mechanic's advice? Thanks in advance!
I don't know the details of this particular motor, but I personally would install the bulb. Its got me back to the dock a couple times in my boating history, i.e. fuel pump issues.
I have two 2006 225 HP Optimax. They DO have to have the primer bulbs. They have some sort of check valves that are necessary for the engine to run properly. Somebody told me the same thing-I got the same result....
Thanks for the help. The bulb will go on today!
Call Burris marine in newLondon NC he be merc certifide mech