SWC Forums

Pull up a chair...let's talk fishing.

5200 removal
 
Notifications
Clear all

5200 removal

10 Posts
7 Users
0 Reactions
24.6 K Views
Barry Turano
(@barryturano)
Famed Member
Joined: 17 years ago
Posts: 2720
Topic starter   [#46026]

Last year I had a hawse pipe installed on my forward deck. It did not work out well, so I had a hatch fabricated for my anchor rode. Installed it last week, tried to remove the hawse pipe. NO WAY it was sealed with 5200. Went to another site and asked about removing 5200. I was given 2 options. Heat Gun or DeBond. Since I did not have a heat gun and was reading about the drawbacks of it I decided to go the DeBond route. Ordered a 4 ounce spray can. Removed the screws sprayed in the holes. Then spayed it around the edge of the hawse pipe. After about 2 minutes I was able to get a metal scraper under it and it lifted right up. Used a little more to clean the excess off the deck. This stuff is absolutely amazing it ate right through the 5200. Just thought I would share.



   
Quote
tracy
(@)
Estimable Member
Joined: 14 years ago
Posts: 105
 

thanks for the info Barry, I was wandering how I was gonna get that stuff off



   
ReplyQuote
zigzag
(@)
Noble Member
Joined: 22 years ago
Posts: 1863
 

that is the first time I have heard of anything working with 5200, thanks for the info.



   
ReplyQuote
(@curmudgeon)
Noble Member
Joined: 21 years ago
Posts: 1317
 

Picture of your hatch? I'm about to install a hawse and sure would like an alternative ... :chin:



   
ReplyQuote
Barry Turano
(@barryturano)
Famed Member
Joined: 17 years ago
Posts: 2720
Topic starter  

Made by Fin Addict in Benson. Picture was before I cleaned up the deck.

Check the Custom Hatches thread in this forum20151024_105458_715_908.jpg



   
ReplyQuote
Kevin
(@bodie)
Noble Member
Joined: 21 years ago
Posts: 1795
 

Thanks for that info



   
ReplyQuote
Barry Turano
(@barryturano)
Famed Member
Joined: 17 years ago
Posts: 2720
Topic starter  

If any one needs this stuff here is a link.
http://www.debondcorporation.com/products/marine-formula



   
ReplyQuote
Bill Jolly
(@barnaclebill)
Honorable Member
Joined: 20 years ago
Posts: 468
 

I didn't think there was anything that would take 5200 off other than abrasives, thanks for the info.



   
ReplyQuote
Jeff Schmucker
(@rustyone)
Noble Member
Joined: 16 years ago
Posts: 951
 

I looked at the MSDS and it appears the primary ingredient is a member of the Glycol family. We use a glycol ether/peroxide mixture to soften thick film polyurethane coatings ...... Hmmmmmmm

Is it expensive?



   
ReplyQuote
Barry Turano
(@barryturano)
Famed Member
Joined: 17 years ago
Posts: 2720
Topic starter  

I bought the 4 ounce spray. Like $18.00 + shipping. The 12 ounce I thinks about $28.00



   
ReplyQuote
Share: