SWC Forums

Pull up a chair...let's talk fishing.

A little help on sh...
 
Notifications
Clear all

A little help on shift cable replacement?

10 Posts
6 Users
0 Reactions
6,239 Views
Chris
(@)
Prominent Member
Joined: 21 years ago
Posts: 802
Topic starter   [#27770]

Hey all. Time to get some fixin done on the boat. My boat has Kiekhaefer Zero Effort Controls with separate shift and throttle levers. Last season the shift lever started to stiffen with time. Eventually the cable appeared to snap and needs to be replaced. I think the connection at the base of the lever snapped by the way that the lever moves very freely now. I was hoping to use the existing cable to fish through a new cable. Anyone know if the cables normally come in standard lengths and connectors? I can't measure the existing cable as it is still in-place and as I stated I wanted to use it to fish the new cable through. In other words how can I get the new cable length before I pull the old cable out? Any suggestions on where to get a new cable? Any advice would help prior to me jumping into it this weekend.

Thx Rascal



   
Quote
Barry Turano
(@barryturano)
Famed Member
Joined: 17 years ago
Posts: 2720
 

Check Paxton Marine in Wilmington. They will have Teleflex cables they come in set lengths 13,14,15, feet etc.



   
ReplyQuote
James
(@)
Noble Member
Joined: 20 years ago
Posts: 908
 

Tape a length of small rope to the cable and pull it through. Take the old cable and buy the one you need. You still have the rope to fish the new one through.



   
ReplyQuote
Tom
 Tom
(@seahorse)
Noble Member
Joined: 19 years ago
Posts: 1167
 

Check Paxton Marine in Wilmington. They will have Teleflex cables they come in set lengths 13,14,15, feet etc.

Can't buy from Paxton unless your a marine repair shop or business they don't sell to private individuals. Island Tackle can order anything you want from them , they get a delivery every day.



   
ReplyQuote
Chris
(@)
Prominent Member
Joined: 21 years ago
Posts: 802
Topic starter  

Thanks guys. I was hoping to pull once and not twice. May not be possible.



   
ReplyQuote
Barry Turano
(@barryturano)
Famed Member
Joined: 17 years ago
Posts: 2720
 

Check Paxton Marine in Wilmington. They will have Teleflex cables they come in set lengths 13,14,15, feet etc.

Can't buy from Paxton unless your a marine repair shop or business they don't sell to private individuals. Island Tackle can order anything you want from them , they get a delivery every day.

You are correct Tom. I am just so used to them delivering every day to SWM I forgot they are wholesale only ๐Ÿ˜ณ



   
ReplyQuote
Andy Duskie
(@)
Noble Member
Joined: 19 years ago
Posts: 1589
 

Don't forget about Lighthouse Marine, which is right up the street from Paxton. They are a wholesale dealer that also deals with the public. He has a whole wall of shifter cable's in stock.



   
ReplyQuote
Coastal Pursuit
(@coastal-pursuit)
Trusted Member
Joined: 20 years ago
Posts: 70
 

You can find the leangth on the cable usually near the shifter. It should be stamped in the cable housing below the shifter,or sometimes by the engine.



   
ReplyQuote
Chris
(@)
Prominent Member
Joined: 21 years ago
Posts: 802
Topic starter  

CP- Good word there. Thanks man. That should save me a bit of work. I figure snaking with the existing cable will be easier than pulling rope.



   
ReplyQuote
Coastal Pursuit
(@coastal-pursuit)
Trusted Member
Joined: 20 years ago
Posts: 70
 

If you dont have any really sharp bends I have heard of threading the two together. But be carefull you could end up bending the threaded part of the cable!



   
ReplyQuote
Share: