SWC Forums

Pull up a chair...let's talk fishing.

Boat trailer hub qu...
 
Notifications
Clear all

Boat trailer hub question

3 Posts
3 Users
0 Reactions
6,220 Views
Jason Oakes
(@bottomdollar2)
Reputable Member
Joined: 20 years ago
Posts: 300
Topic starter   [#6843]

If a trailer is equipped with bearing buddy's, should there be an unplugged grease hole / path in the spindle from inside the gap between the two bearings to out the back of the spindle / torsion bar assembly? I know that when you pump in grease it has to go somewhere or it will blow out the seal, but should the pressure relief path be open all the time? The hole is not threaded. Has something fell out, or been left out, of all four spindles or is this the way it's supposed to be?
Thanks in advance
BottomDollar



   
Quote
Tommy Stewart
(@)
Noble Member
Joined: 20 years ago
Posts: 1272
 

There shouldn't be an open hole. The bearings kept going out on my uncle's bass boat trailer and we found the same problem. Even though there is no threads you can still screw a grease fitting in. That's what we did and he never had another bearing go out.



   
ReplyQuote
tomgso
(@)
Trusted Member
Joined: 22 years ago
Posts: 56
 

I have never seen any type of hole.You need to repack at least once a year if you trailer much. the grease breaks down and wash out.plus change them out every other year and the set that you take out keep as a emergency set for on the road.



   
ReplyQuote
Share: