SWC Forums

Pull up a chair...let's talk fishing.

CB Inlet low tide d...
 
Notifications
Clear all

CB Inlet low tide depth?

12 Posts
6 Users
0 Reactions
29 K Views
Tom
 Tom
(@seahorse)
Noble Member
Joined: 19 years ago
Posts: 1167
Topic starter   [#47494]

Anyone have first hand Intel on CB Inlet? Heard the hopper dredge was in there this week but personally didn't ever see it. I know it's all deep except for across the channel at 4 & 3 where it was only 6 ft at high water.
Planning a 5:00 am trip Monday and it's almost low at get time. Thanks for recent info



   
Quote
Mark Cogdell
(@markc)
Reputable Member
Joined: 20 years ago
Posts: 211
 

marked 2.5' (current was still flowing out pretty good too) last monday morning when we were stream bound on a buddy's contender. This was from the ducer on the bottom of the hull so I'd say it was actually 3.5-4' deep. Its a shame they won't let that big ass cutter head dredge that is sitting in there dig the channel out.



   
ReplyQuote
Tim elrod
(@)
Noble Member
Joined: 18 years ago
Posts: 1002
 

I stuck the bow out yesterday around 4pm. I never saw over 3.8ft anywhere. I would say it is impassable in anything over 23ft.



   
ReplyQuote
Tom
 Tom
(@seahorse)
Noble Member
Joined: 19 years ago
Posts: 1167
Topic starter  

I stuck the bow out yesterday around 4pm. I never saw over 3.8ft anywhere. I would say it is impassable in anything over 23ft.

It's passable and plenty deep except for the sand bar across the channel between buoys 4 & 3. There's no way to get over the bar no matter what you do at low tide or two hours before or after. With an east or N East wind causing a swell high tide would be the only way it's passable and that's for center console boats that can lift their engines. Inboards are SOL :wall:



   
ReplyQuote
Amanda
(@blueoceaneyez)
Famed Member
Joined: 21 years ago
Posts: 3235
 

4.5', 45 min after low tide, was the shallowest I saw Tues on that bar. Read the water & favored the can.

Tom, what does ur boat draft? Just curious..



   
ReplyQuote
Tom
 Tom
(@seahorse)
Noble Member
Joined: 19 years ago
Posts: 1167
Topic starter  

Draw 4 ft when full of fuel which is 600 gal. I had full tanks last time through. Coming in 1 1/2 hours after low tide I made it but going out 45 minuets after dead low I hit



   
ReplyQuote
Amanda
(@blueoceaneyez)
Famed Member
Joined: 21 years ago
Posts: 3235
 

The Merritt went in there this afternoon for about an hour throwing sand off the bar. Not sure what depths he created; maybe someone else will chime in.



   
ReplyQuote
outdoors
(@)
Reputable Member
Joined: 18 years ago
Posts: 342
 

Went through yesterday 4/24 at dead low full moon tide.
It was 7.5 most of the channel, then 6 foot well beyond the last can.
This was on my skiff, so add about a foot because I was not on plane.
Went through this afternoon, pretty much the same.



   
ReplyQuote
Tom
 Tom
(@seahorse)
Noble Member
Joined: 19 years ago
Posts: 1167
Topic starter  

Went through yesterday 4/24 at dead low full moon tide.
It was 7.5 most of the channel, then 6 foot well beyond the last can.
This was on my skiff, so add about a foot because I was not on plane.
Went through this afternoon, pretty much the same.

Hate to say this but after reading this and reading a friends comment on another blog saying he read 3.5 at low tide today I think he's way closer to th actual depth. I suggest it's every man and woman for himself. Everyone has their depth finder set up differently and suggest you don't relie on anyone but yourself. With that said unless the dredge opened up the channel today, there's no way there's anything close to 6 ft at low tide sorry. Apologize for sarting this post. It's not helpful and somebody's going to get hurt trusting there info.
๐Ÿ™„



   
ReplyQuote
Mark Cogdell
(@markc)
Reputable Member
Joined: 20 years ago
Posts: 211
 

I plan on going out it about an hour or so after low in the morning. I'll try to remember to get some real numbers in there on the last bar. I do know that the south side out by the #1 can seemed to be the deepest last Saturday afternoon when I ran out.



   
ReplyQuote
Mark Cogdell
(@markc)
Reputable Member
Joined: 20 years ago
Posts: 211
 

At 0805 the lowest I marked was right at 5.5' on the north side around buoy 4. The USACE dredge merit was working just south of the green cans between #3 and #5.image_559.jpeg



   
ReplyQuote
Drew Sallean
(@aj64)
Eminent Member
Joined: 12 years ago
Posts: 21
 

I got 6.5 ft leaving as the tide just started falling yesterday. I passed the Merrit in the ICW on the way down from Wrightsville. Glad she is there and working.



   
ReplyQuote
Share: