SWC Forums
Pull up a chair...let's talk fishing.
Does anyone have a recommendation on a good brand and size drift control sock for inshore and offshore bottom jigging to slow the drift of a Sea Hunt Gamefish 25? I would only be using it in light to moderate wind conditions.
I'm also considering the possibility of stepping up to a coast guard approved sea anchor to have as a safety device but also use for dual purpose as a drift sock. Any advise would be appreciated.
I use 5 gallon buckets with a 2 to 3 inch hole in bottom. Works good!
I use BPS blue one. I got the biggest one they had and it was less than $50. Works pretty well, gives you a couple extra drops before you have to pull around and it’s easy to reset or pull in.
A company in Ohio.Amish Outfitters. Get the trolling bags stronger than any drift Sox made. They also sell tackle storage and lots of other products. I have used a lot of there stuff. All is very well made.
I use 5 gallon buckets with a 2 to 3 inch hole in bottom. Works good!
X2! its amazing what 2, 5 gallon buckets will do. i glued a section of fun noodles around half the rims. this keeps them on top and keeps them from spinning. whole setup costed about $3. no rinsing off afterwards, no worries of tearing, etc
Can you post pics of buckets and setup?
I have always used a sea anchor for my 45 foot vessel. It has come in handy as a safety in bad unpredicted winds also. I have an extra one for 800$ if you want to buy a 12 foot paratech. I set it up on a buoy and would cast it off when a large fish would strike, then go back and pick it up again.
Thanks for the information. I'll check out these new options. I'm looking forward to fishing some ledges this year.