SWC Forums

Pull up a chair...let's talk fishing.

Electramate Reel Re...
 
Notifications
Clear all

Electramate Reel Repair

5 Posts
4 Users
0 Reactions
13.3 K Views
Chris Franks
(@captkrunch)
Estimable Member
Joined: 20 years ago
Posts: 155
Topic starter   [#38958]

I am tryhing to figure out why a reel I am working on is not running. (Other than the fact I have it apart)

At ifrst I thought it was the switch but after taking it out and putting it on a meter it appears to be fine. Nothing going through it until pressed. (using ohm meter)

The cord seems to meter to meter out fine.

When I put the meter to the cord and run it through the motor, it shows no resistance. It has been a while since my electricity classes but if i remember correctly that meas there is a short in the motor, right?

The casing is plastic so I cn not check continuity there.

Other than the manufacturer, is there any one who has parts or works on these?



   
Quote
roy rauert
(@)
Estimable Member
Joined: 14 years ago
Posts: 143
 

Maybe the brushes are worn out.



   
ReplyQuote
Wes Hudson
(@reznor)
Reputable Member
Joined: 16 years ago
Posts: 441
 

Call Louis @ island Tackle in Carolina Beach. He might know someone locally that can repair it.
Otherwise, I think they are in Greensboro so I would call them and see about getting an RMA.



   
ReplyQuote
Jason Oakes
(@bottomdollar2)
Reputable Member
Joined: 20 years ago
Posts: 300
 

That means the motor circuit is "Open", burshes worn out, or there is a break in one of the connections to the brush, or a brush is stuck / spring broken not pushing in to make contact, or a break in the motor leads somewhere in the circuit where you had your meter connected.
You can take the brushes out of those motors I'm pretty sure.
I mostly use NG reels, haven't been in my "red drives" in a while but I think the brushes are replaceable.
I think i remember putting ink pen springs on the brushes or something, back years ago to get one running?



   
ReplyQuote
Chris Franks
(@captkrunch)
Estimable Member
Joined: 20 years ago
Posts: 155
Topic starter  

Thanks for the replies. I will give Electramate a call tomorrow.



   
ReplyQuote
Share: