SWC Forums
Pull up a chair...let's talk fishing.
Does anyone have a garmin 73sv with the cradle design (poor design) and have trouble with it cutting off at speed?
Can you clarify what you mean about it cutting off at speed? Do you mean its no longer reading bottom or the unit itself shuts completely off? If the sonar is not reading at speed, then the transducer needs to be adjusted. If it is cutting off completely then that would be a different issue b/c the only way it would cut off completely is if you lost power to it or there is an internal issue in the unit. But the speed would not have anything to do with that unless there is a loose wire somewhere and the higher speed is vibrating something around causing it to cut off.
I just installed the 74dv this year and I love it. Does your unit cut completely off from loss of power as Titan said? I chose to flush mount mine and even with flush mounting you need to leave the dash mount "cradle" on the back of the unit. On the back of the cradle it has a piece that you put your power cord through and it locks into place holding your transducer wire and power cable into place so they can not fall out. I hope this helps as I did not understand how the cords were supposed to stay on either when first mounting the unit and garmin doesn't tell you to mount with the cradle still connected.
Sorry not real clear it is cutting off completely so the cradle is loosing power at the snap connections when hitting waves and bumps not a real good design i like the screw in connections. Is there a way to tighten the connection?
You might not be loosing power at the unit itself. Probably need to check the connection from your Power distribution panel. Maybe its loose there. Guess you could turn it on while the boat is on the trailer and wiggle the back of the connectors only. If it cuts out that is the problem. If it does not cut out then just follow the power cable to the source.
I just installed the 74dv this year and I love it. Does your unit cut completely off from loss of power as Titan said? I chose to flush mount mine and even with flush mounting you need to leave the dash mount "cradle" on the back of the unit. On the back of the cradle it has a piece that you put your power cord through and it locks into place holding your transducer wire and power cable into place so they can not fall out. I hope this helps as I did not understand how the cords were supposed to stay on either when first mounting the unit and garmin doesn't tell you to mount with the cradle still connected.
I bet this is the correct answer. I didn't install correctly and had the same issues.
Larry,
Lousy design. Garmin sent me washers first, then new cable neither of which resolved problem. Ended up using rescue tape to secure connection. Worked.
I have a 741xs and it would cut off when I'm running sometimes. Heard from several people that Garmin units are susceptible to power fluctuations and the unit will shutdown automatically as a unit protection thingy. Found out my issue was the connections on the battery were nasty, after cleaning and replacing I haven't had an issue.
Might be something to look at also.