SWC Forums

Pull up a chair...let's talk fishing.

Long beep on honda ...
 
Notifications
Clear all

Long beep on honda 130

5 Posts
4 Users
0 Reactions
19.7 K Views
Nathan
(@ntbrinkl)
Reputable Member
Joined: 13 years ago
Posts: 216
Topic starter   [#43230]

This past weekend we got our boat back after having some winter maintenance done to it and the trailer. We started both engines and they idled fine. We back out of the dock and went about 200 yards slowly letting them warm because it was cold. Then the alarm goes off one solid beep that doesn't go away until we shut it down. We then start it back up and continue with no beep for a couple hours of testing some new stuff out and all is well the rest of the day.

Here's the thing, one of the engines had a little oil running out at the spacing below where the cowl goes on(maybe 6 inches lower than where the cowl sits). The only thing I could think is that the guy we had doing all of our maintenance put too much oil in and it blew out of the top of the dip stick, leaking and causing the alarm to go off? Then once it leaked the dip stick settled back down and the engine was fine? Any other ideas. I just figured a well know boat shop wouldn't over fill the oil so I hope its not something else.



   
Quote
BRIAN
(@bharbaugh)
Prominent Member
Joined: 19 years ago
Posts: 687
 

This guy had the same problem and it was a temp switch.

http://www.marineengine.com/boat-forum/showthread.php?384109-honda-bf130-2004-long-beep-after-run-about-100-yrds



   
ReplyQuote
Mike Miner
(@cullowhee1)
Estimable Member
Joined: 14 years ago
Posts: 85
 

might be the Fuel Water separators inside cowling (there's 2 of them) take out the screws and empty both - I had same issue - found honda manual on this...long steady beep on honda is water in fuel...(i'm not a mechanic, so if someone tells you different - listen to them) - but sounds like what happened to you is same thing that happened to me last year and that took care of it-worth checking out anyway - hope that helps, good luck



   
ReplyQuote
David
(@tanktom)
Honorable Member
Joined: 18 years ago
Posts: 525
 

My experience with a constant signal on my BF200 was the oxygen sensor. Would go off and continue until shut engine off and restart. Would run fine at normal speeds and go off again when at idle.



   
ReplyQuote
Nathan
(@ntbrinkl)
Reputable Member
Joined: 13 years ago
Posts: 216
Topic starter  

Thought I was going down to work on it today but things came up, so I'll let yall know what I figure out.
Thanks for the inputs



   
ReplyQuote
Share: