SWC Forums

Pull up a chair...let's talk fishing.

Plumbing Dual Bilge...
 
Notifications
Clear all

Plumbing Dual Bilge Pumps

9 Posts
6 Users
0 Reactions
17.6 K Views
sammy balatsias
(@sammydgreek)
Eminent Member
Joined: 13 years ago
Posts: 20
Topic starter   [#39375]

For safety and piece of mind I installed a second bilge pump with the inlet approximately 6" above the primary pump and am curious if I should install a check valve and tie it in the main line or run a separate hose and drill a new thru hull. Any advice is greatly appreciated. I am talking about the transom bilge area on a 23ft CC. Thanks in advance!!



   
Quote
Dale A. Tycast
(@toad)
Prominent Member
Joined: 18 years ago
Posts: 722
 

Good question Sammy. I'm thinking about doing the same as my pump just crapped out. Figured two would be good for a backup.



   
ReplyQuote
Dale A. Tycast
(@toad)
Prominent Member
Joined: 18 years ago
Posts: 722
 

Good question Sammy. I'm thinking about doing the same as my pump just crapped out. Figured two would be good for a backup.



   
ReplyQuote
sammy balatsias
(@sammydgreek)
Eminent Member
Joined: 13 years ago
Posts: 20
Topic starter  

Toad,

I tried tying them both together without a check valve and water recirculates from one pump to the other and does not discharge out of the boat. Definitely not good. Hence my question and curious how the manufacturers and professional riggers do it.



   
ReplyQuote
David Lucas
(@)
Noble Member
Joined: 19 years ago
Posts: 1100
 

Don't worry about messing with a check valve, just put another thru-hull fitting and don't worry about it. If the discharge is below the water line, don't use plastic.



   
ReplyQuote
Andrew Elliott
(@)
Estimable Member
Joined: 16 years ago
Posts: 163
 

Negative on the check valve. Run a separate hose with new thru hull and separate electrical circuit. Be sure to loop you hose upward or the pump can become air locked.

Here is my recent install:
http://www.thehulltruth.com/boating-forum/593013-bilge-pump-upgrade-rule-1500-x-2-a.html



   
ReplyQuote
BRIAN
(@bharbaugh)
Prominent Member
Joined: 19 years ago
Posts: 687
 

Im probably a smaller boat, but I bought a spare pump and hooked clip on battery leads to it. I can hook it up to my batteries and put it where I want it. I think I have 8 foot of hose on it ready to go.



   
ReplyQuote
sammy balatsias
(@sammydgreek)
Eminent Member
Joined: 13 years ago
Posts: 20
Topic starter  

I greatly appreciate the responses and going to plumb the second one separately like advised and possibly carry a small spare! Thanks again. This website is awesome and kudos to FPT!!



   
ReplyQuote
Stuart Ussery
(@lookintohookem)
Honorable Member
Joined: 13 years ago
Posts: 701
 

Im probably a smaller boat, but I bought a spare pump and hooked clip on battery leads to it. I can hook it up to my batteries and put it where I want it. I think I have 8 foot of hose on it ready to go.

I did the exact same thing, have it in a dry bag for my use or if need be to toss to somebody if they need a spare.(hope neither ever happens...BUT)



   
ReplyQuote
Share: