SWC Forums
Pull up a chair...let's talk fishing.
I have never had a big load in my 178 DLX Skiff w/70 Suzuki until recently. A friend and I took ours sons and 3 of their friends camping on an island in the ICW for my sons birthday. The boat would only turn 3000 rpms and about 10 knots. Then the testing began. With myself in the boat it will only turn 4800 rpms at WOT and 26 knots. The prop is a 13 1/4x 17. I think if I go with a 13 1/2 x 15 I will get the rpms and the low end pull the engine is supposed to have. Any thoughts, suggestions?
First make sure the motor is at the right height. Run it at speed with just you onboard and check water flow at the vent plate, plate should be just out of the water. With that done, determine what the WOT range is for that boat and proceed from there. Dropping the pitch (lower number) 2* will increase RPM 200-400, with the inverse for raising the number. I would think the 15" would get you into the 5000s, with the diameter change being negligible.
I'm not that familiar with that boat and a 70, but 8 folks plus gear is a pretty hefty load, as you experienced with a 1800 RPM loss ...
call Martin at Coastal Propellers in Wilmington. He can help you out.