SWC Forums
Pull up a chair...let's talk fishing.
Hey guys, bought a gallon of seastar and was going to flush/bleed the steering this weekend. Get over to her and I see the fluid is RED, so it is obviously ATF or aviation fluid
Would you guys :
- Assume its ATF, and just flush a few quarts through the system
or
- Purge the system with the SeaStar fluid since I already have it
I have read that Mil-h-5606 and ATF do not really mix well, this has me uncertain.
I could try to find out who installed the autopilot on the boat if necessary, as it was probably done then.
Thanks!
I thought that the Sea Star systems used Hydraulic fluid which is clear. Do you have an inboard with power assist steering? Or an outboard? The rams on a outboard use clear hydraulic.
when i replaced the seal on my hydraulic steering the guy helping me put transmission fluid in it when we finished, said it was a little thicker and would last longer. worked for at least 2 years (sold the boat) I dont know if you can mix the 2 though.
If im not mistaken Seastar states in there manual ATF can be used in an emergency. To me that means im on the water steering is out and ATF is all i have to put in it. They also say to flush and refill the system with the correct fluid when you get to where you can change it. Personally i would not use anything but the Seastar fluid and if i thought my boat had ATF in it i would flush it and refill with Seastar fluid. Its the steering on your boat that quits on the water 40 or 50 out its gonna be a long ride home.
X2 on flushing ATF out. Use the seastar fluid. It's expensive, but I want the good stuff while I'm over the horizon.
To keep it from mixing, use the wrench provided with the seal kit to unscrew both end caps and steer the the wheel to push out most of the fluid. Use a catch pan under the cylinder to catch the fluid. Then put the caps back on and go through the normal bleed procedure. I just did this this past weekend... The new seal kit comes with a new style cap with multiple holes for the wrench to grab. Much better for tight situations. I'm going to start appling CRC656 to the cylinder shafts after I thoroughly wash them after each use. This is the second set of end caps since 2008. They tend to leak over the off season.
Total flush and refill with the Seastar you have.Dont forget to activate your auto pilot when you flush and refill.
Just leave the ATF. It's fine. Why are you even flushing or messing with the system? You can dilute slightly with diesel fuel to bring down the viscosity.
Thanks so much for the input guys.
Purchased the boat 3 years ago, autopilot was already installed and guessing the ATF was put in when AP was installed.
This problem arose when I went to bleed the steering, as when it doesn't get used for a while it will not respond to a slow right turn of the helm, it takes a little faster of a turn to get it "click" to respond. After I turn it left and right a few times it works both ways with even the slightest wheel movements so not really a problem then.
Was going to try clean the check balls and rod in the helm if the flush did not fix the problem.. but have not looked into that deeper yet.
I had a 28 privateer( inboards) that the guys building the boat used texaco aircraft hydraulic fluid (red) in, was a seastar steering ram and helm, and after more than 8 years the system was still perfect and no leaks, go figure.
Sea Star says in the manual that mil-spec 5606 (red aviation hydraulic fluid) is an acceptable sub for their fluid. I used it on a helm change with a furuno autopilot several years ago and never had a problem. And its way cheaper than sea star fluid. You can order it from Aircraft Spruce and Specialty.
BTW I've heard of guys using trans fluid with no probs also and its way cheaper than 5606.