SWC Forums
Pull up a chair...let's talk fishing.
fished last sunday and cranked the boat and heard a fast clicking noise between the lower engine where it connects to the lower unit. did not seem to effect the performance.when I put it in reverse it sounds sort of like a belt slipping any help, its a 2010 200 4 stroke yamaha. Very faint noise but something i have not heard before.
Call Chris Burleson up at Burleson Marine on 70 (Morehead). He will tell you what it is and if you need it to be looked at. He is the best Yamaha mechanic in the area and will shoot straight with you.
Another very good mechanic is Steve at Coral Bay. He is very good on Yami's.
I know there is a plastic bushing around the drive shaft/coupler down in the area you describe on my OX66 which has been known to make a faint 'belt squeal' noise from time to time.
All input is that its not harmful and that to make the noise go away would be rather costly as it involves pulling the powerhead.
I'd call either of the guys suggested above, to confirm.
Question: Have you ever connected a garden hose to the connection at the base of the cowl on the starboard side to flush the engine and then started the engine and let it run?
i have flushed engine with garden hose but did not have engine running. engine has less than 100hrs.
How do you flush an engine without the engine running?
You are not supposed to run the engine with Yamahas with just the flush port. It is designed to flush without the engine running. If you want to run the engine to flush it you need muffs at the impeller intakes or you will burn up your impellers because they will spin dry. At least, thats what I was told by a master Yamaha mechanic.
How do you flush an engine without the engine running?
Using the water pressure from the hose to circulate water through the powerhead. If you start the motor while using the powerhead flush fitting, you are actually "back-feeding" the water pump, which can damage the pump. This can result in the "squeaking" noise described above
I was also told that yamaha engine would run hot if left running awhile with mufflers on with water hose while flushing by a yamaha mechanic?
I was also told that yamaha engine would run hot if left running awhile with mufflers on with water hose while flushing by a yamaha mechanic?
Too many variables to comment. Water pressure/flow rate from hose? Type of "headphones" i.e. single or dual feed etc...
Fishing at Ocracoke last year I heard a faint ticking in my lower unit of my Yamaha f250. Day or two later it suddenly got louder. Thought I was done for the trip and I was really concerned about what I was hearing. Got it back to the house we were staying and discovered that the sac anode was gone. The bolt hanging down was making the loud rattle. It had started off loose and that was the faint noise....when the anode came off the bolt made much noise.
just talked to burleson and he said its probally a bushing that needs to be greased and cleaned when I get service done which is close to time.
Glad you hooked up with Chris. He will take good care of you if you use him.