SWC Forums
Pull up a chair...let's talk fishing.
I would like to have a discussion on the use of a planer rod. Not so much the components, but instead drag settings and proper steps to take once you see the planer trip (signaling a strike).
My setup includes a tiagra 50w lrsa, bent butt rod with swivel tip from pinnacle marine, 600 yards of 130# Jerry brown hollow core, inline bridle, #12 old salty, ~100 feet of 100 pound mono.
I caught one wahoo and one gaffer dolphin on this setup the only time I took it with me this past season. Despite that success, I still struggled to know if I was doing it right as we had probably half a dozen other strikes.
I feel that once the planer trips that the drag is way too tight potentially tearing the hook from the fish's mouth, but at the same time I don't want to loosen the drag dramatically giving the fish slack and causing him to come unbuttoned.
Questions:
What to do with the drag lever once I get a strike?
What should the drag be set to at 'STRIKE'?
Hopefully these are relevant questions. If not, maybe someone (or a few people) can go through their procedure.
You want just enough to drag to keep the planer consistently pulling line off. If it creeps every now and then that is ok. Once a fish hits you need to back off the drag. Not a ton but get off to let the fish run to an extent. I don't have actual drag setting as we go by feel but I'm sure others do.
What Will said. Set the drag loose enough the line creeps a little when you go over waves. Otherwise you may miss strikes/small fish as they will pull a little more line than going through a wave but nothing like a big fish. Trip planer and check bait often (every 30-45min) or else you may be pulling half a bait.
When a big fish is on, you may not have the typical screaming drag. May just see that line doesn't enter water as steep as before. Whenever you realize there is a fish, back off your drag to something in the 15-20# range. If you like, take a sharpie (or sticker) to mark this setting on the reel. Otherwise you risk line breakage when fighting fish. I lost a stud wahoo on planer rod last year when we forgot to back off drag. He popped 130# mono about 30' behind the boat. Upgraded to 200# pound so that if we forget to back off drag again, we have a little more room for error. Hopefully I won't make that mistake twice :wall:
Hope this helps
As stated above. You'll still lose fish, of course, especially if you hook something other than a wahoo. Lost the biggest dolphin I've ever seen in person this past spring when it started jumping and threw the hook. No way to keep the line tight with that planer bouncing around.
I agree with all the posts. We use planner rods every trip offshore. they are worth their weight in gold.
Chris
First off you need to set , or blueprint your drag each time you go out. It only takes 5 mins. Heat up drag by pulling line off under tension and wind up tight. Set strike on a 50 planer setup at about 25 lbs. slide lever back and mark 8 to lbs. use a sharpie. As stated above use just enough pressure to stop planer when deployed and it creeps when surging. The moment you see the rod tip bounce a little pull lever back to 8 to 10 lbs mark. You will not lose fish a this setting.