SWC Forums

Pull up a chair...let's talk fishing.

Which trolling moto...
 
Notifications
Clear all

Which trolling motor

7 Posts
5 Users
0 Reactions
15.2 K Views
Brandon Zoladz
(@)
Estimable Member
Joined: 11 years ago
Posts: 178
Topic starter   [#47357]

Hey guys, I have been debating getting a trolling motor for the past year now... and I think I am going to go ahead and start looking. However, I have a few problems. 1. I have a bow-rail that is raised 16" and would be near impossible to take off 2. Nav light & cleat in the way for mounting 3. 32" from bow to waterline. I figured i'd ask what you guys suggest before heading over to bass pro and getting directed to the GPS Minn Kota, I am not trying to break the bank. I know this will be a pain in the ass but I am looking at what my possibilities are.img_2376_566.jpgfullsizerender_2_971.jpg



   
Quote
Brandon Zoladz
(@)
Estimable Member
Joined: 11 years ago
Posts: 178
Topic starter  

Sorry about first pic sideways, when clicking the full size image it should be upright

Also weight is usually around 1700-1800 when fishing.



   
ReplyQuote
zigzag
(@)
Noble Member
Joined: 22 years ago
Posts: 1863
 

you could cut the front center out of the bowrail, leave enough tubing in front of the brace to put a pvc cap on it, then your trolling motor will be in the water about centerline and will fold up and lay along your gunnel



   
ReplyQuote
Amanda
(@blueoceaneyez)
Famed Member
Joined: 21 years ago
Posts: 3235
 

I would remove the entire bow rail - or - cut the center point out as suggested above & have a split bow rail, kinda like they have on older C Skiffs. That should leave you with enough room to mount the trolling motor as u need, even if u have to angle it, w/o interfering with the light and cleat. ?



   
ReplyQuote
Brandon Zoladz
(@)
Estimable Member
Joined: 11 years ago
Posts: 178
Topic starter  

Thanks for the input, do you guys think a 52" shaft would be too small for 32" bow platform to water line? 12v or 24v?

just wondering because there is a huge jump in price going from 52" to 60" shaft length motors



   
ReplyQuote
icecreamman
(@)
Noble Member
Joined: 21 years ago
Posts: 2017
 

Your going to have to cut the bow rail, remove the line guide (?) & remount the bow lights.
Go with 24volts, 80 thrust is the biggest you can get without going to 36V ( 3 batteries ).
Not sure your boat will go shallow enough to reap the benefits.
Trolling motor may cost upwards of $1200. without batteries or installation .... ICM



   
ReplyQuote
Scaramucci
(@)
Honorable Member
Joined: 12 years ago
Posts: 588
 

I have an engine mount Minn Kota (Riptide EM 55). Mounts to the cavitation plate on your outboard. Never in the way, never hits bottom. You steer from the helm. I love it. I can troll all day on one 12V battery, and it will push my Carolina Skiff about 4-5 mph, but I just use it mostly to control my drift. With battery, I'm in it about $850, and it took me about 30 minutes to install.

I'd bet if you cut that bow rail, you are going to make it alot less sturdy.



   
ReplyQuote
Share: