SWC Forums

Pull up a chair...let's talk fishing.

WOW I'll know next ...
 
Notifications
Clear all

WOW I'll know next time

10 Posts
8 Users
0 Reactions
24.8 K Views
Brian Newton
(@flyrod72)
Eminent Member
Joined: 12 years ago
Posts: 16
Topic starter   [#43429]

Checking out motors. Hooked both up on muffs. One peed good other one not so good. Go get new kit and put it on. Hooked back up. Still same thing. Took back off to make sure it was right and it was. Putting it back together thought I would check hose coming from block to peer and low and behold there was a dang screen in there and guess what PLUGGED. Unclogged and works great. Didn't need a pump after all. WOW. Was getting a little concerned as we'll be coming down sat.



   
Quote
Randy Hoffman
(@)
Estimable Member
Joined: 13 years ago
Posts: 192
 

Interesting...what motor?



   
ReplyQuote
John Rakoci
(@)
Noble Member
Joined: 14 years ago
Posts: 2331
 

Mud wasps and other critters love nesting there in the fall. Usually a piece of 80# or higher mono will clear it out.



   
ReplyQuote
Brian Newton
(@flyrod72)
Eminent Member
Joined: 12 years ago
Posts: 16
Topic starter  

2000 Johnson 150 ocean runner. There is a long tube screen that sits inside the block. It's supposed to keep pee hole from clogging. Well I guess it work LOL



   
ReplyQuote
Larry Rowland
(@lwr37)
Famed Member
Joined: 16 years ago
Posts: 2552
 

This is pretty common.



   
ReplyQuote
Dave Prentice
(@boatzilla)
Trusted Member
Joined: 16 years ago
Posts: 78
 

I have a Suzuki 250, if I get into sand or mud it will quit flowing even with a new impeller. I keep a 5' length of weed wacker line on the boat just for this problem. It has worked every time so far. The motor temp doesn't go up when this happens but it makes me nervous when I don't see the stream.



   
ReplyQuote
Steve
(@)
Reputable Member
Joined: 17 years ago
Posts: 363
 

We guys need to keep a strong stream.....



   
ReplyQuote
Brian Newton
(@flyrod72)
Eminent Member
Joined: 12 years ago
Posts: 16
Topic starter  

And to top it all off. Went to the hook and the port motor stalled. Would not turn over. Got back and had a buddy look at it and the motor is toast. Crank bearings burt. So there goes fishing trip. And a wad of dough for another motor.



   
ReplyQuote
Blake Holcomb/Brad Dove
(@)
Honorable Member
Joined: 20 years ago
Posts: 411
 

turn the crankshaft and rebuild it. shouldn't cost much. I am sure they do a .010 bearing that will take care of that unless it bent the crank really bad.



   
ReplyQuote
JOHNNY CARPENTER
(@)
Noble Member
Joined: 14 years ago
Posts: 1169
 

Mud wasps and other critters love nesting there in the fall. Usually a piece of 80# or higher mono will clear it out.

Works like a charm.



   
ReplyQuote
Share: