SWC Forums

Pull up a chair...let's talk fishing.

Yamaha 150 issue qu...
 
Notifications
Clear all

Yamaha 150 issue question

12 Posts
9 Users
0 Reactions
27.3 K Views
Wesley Atkins
(@wampler24)
Prominent Member
Joined: 15 years ago
Posts: 715
Topic starter   [#34658]

So today I took the boat to Smith Mountain lake as I always do before hauling to the coast to ensure everything is running well. I have an issue. The engine cranked fine the first time. No priming or anything. Cranked right on up. Ran to get some lunch and it sounded good. Stopped for about 45 minutes and when I tried to crank back up it no joy. Turned over and sputtered like it was getting fire but no sustained run. Went back and punched the primer and it tried a little harder to crank but ended up having to goose it a few times and it ran like it was flooded for a minute then smoothed out. Smelled flooded too. So, hooked the tube up, pulled the neighbors kids around and it ran fine. Good RPM no signs of anything. Stopped to swim for about 30 minutes and had the same cranking issue. So, once cranked, I ran it for a few minutes and turned it off and as long as you don't let it sit for more than a few minutes, it will crank up normal. It's only when you let it sit...

Sorry for the long post but any ideas? Plan on pulling it to OKI Saturday for some fishing next week but rethinking that with this cranking issue. Engine only has 75 hours on it and it is still under warranty but I am sure my dealer is booked this time of year...



   
Quote
Greg Cave
(@caveman)
Trusted Member
Joined: 20 years ago
Posts: 78
 

Had the same problem a couple of years ago your injectors are clogged! Do you have a fuel water separator?



   
ReplyQuote
Wesley Atkins
(@wampler24)
Prominent Member
Joined: 15 years ago
Posts: 715
Topic starter  

Yes



   
ReplyQuote
Steve Smith
(@)
Reputable Member
Joined: 20 years ago
Posts: 363
 

May as well pull it to OKI for your vacation. If it doesn't clear up with some running, new fuel, perhaps some fuel additive,.... there are several good shops down there that can do the warranty work for you.



   
ReplyQuote
AboutTime2Fish
(@abouttime2fish)
Prominent Member
Joined: 16 years ago
Posts: 744
 

Check the primer bulb for cracks/leaks/etc. If that is it, don't replace with a cheap one, recommend you replace with one from Yamaha. Also watch it while you try and start the engine to see if it collapses and blocks fuel flow.



   
ReplyQuote
Tripp Murray
(@)
Estimable Member
Joined: 17 years ago
Posts: 185
 

Techron fuel injector cleaner at twice the recommended mix ratio with fuel will usually clean injectors up...



   
ReplyQuote
William McCann
(@werewolf0711)
Famed Member
Joined: 15 years ago
Posts: 3133
 

I would recommend changing the fuel water separator, check the fuel filter on the front of the engine itself for water. Then get a small tank of gas to hook directly to the engine and run a good cleaner through it. Techron, sea foam or something of the like. Then as others have said check to lines and bulb to make sure everything is free and flowing.



   
ReplyQuote
Wesley Atkins
(@wampler24)
Prominent Member
Joined: 15 years ago
Posts: 715
Topic starter  

Well, I begged the dealer and he got me in today. He could not reproduce the problem but he couldn't run it long. He stated the Yamaha primer bulbs have been an issue so they replaced it (under warranty) and said to give it a whirl. They couldn't see anything obvious.

Gonna pull it down and make sure I have radio contact and give it a whirl. Who knows, maybe it will be fine and I won't have to try out my sea tow membership!

Gonna do the water separator and service when I get back. Not due yet but can't hurt!



   
ReplyQuote
Alex Townsend
(@)
Eminent Member
Joined: 15 years ago
Posts: 39
 

I had the same issue and ethanol had messed with the fuel lines and injectors, you may be fine if it was caught early enough. Good luck!!



   
ReplyQuote
Wesley Atkins
(@wampler24)
Prominent Member
Joined: 15 years ago
Posts: 715
Topic starter  

I run stabil like product for ethanol treatment and try to use non ethanol fuel but around here that stuff is like hens teeth! I was wondering too if that could be an issue.... We will find out if the weather lets me out of the waterway next week but anytime I show up the winds seem to follow.



   
ReplyQuote
Tommy
(@shocktreatment)
Honorable Member
Joined: 19 years ago
Posts: 606
 

Changing the water separator shouldn't take but a couple of minutes that is if you have one. Not talking about the filter on the engine. If you don't have one it is a must now a days with the way gas is.
May help clear up some of your problems.



   
ReplyQuote
Matt
 Matt
(@)
Famed Member
Joined: 16 years ago
Posts: 2497
 

Go buy two cans of seafoam and run that through the next tank. You probably got some bad fuel. Definitely could have been the primer bulb leaking air after running but then ot shouldn't start easy the first time. Sounds like bad fuel to me......



   
ReplyQuote
Share: