SWC Forums
Pull up a chair...let's talk fishing.
Looking for advice from anyone with similar problems or issues
I have a 1999 Yamaha 225 with low compression on 1 cyclinder and the idle issue only shows itself at slow idle.- top end and middle are fine. The question is rebuild low cyclinder only or complete rebuild?
My gut says - go for complete rebuild and get some work warranty.
Next question - who would ya'll recommend going the work locally.
I do have a trailer for boat, but prefer not to pull it around with old truck, so someplace where I can run to and have work done works best
Where is locally?
Within running distance of Inlet Watch Marina - they don't do rebuilds.
Those motors have a known corrosion issue that has caused all sorts of problems. I know of two people who have done rebuilds in the past year... one with 225's and one with 250's.
Im not sure where you are but the guy I would talk to, regardless of where you are, is Chris Burleson of Burleson Marine in Morehead. He is, hands down, the best Yamaha mechanic in the area and is straight forward and honest.
Saltwater Marine on Carolina Beach Road should be able to help you. Honest Folks!!!
I second Saltwater Marine. Never had work of this scope performed, but they have serviced our skiff at Inlet Watch for the past 7 years and we have been very pleased with there work and customer service.
SWM, talk to Joel, they'll give you the honest truth on where the engine stands. You get what you pay for....
Those motors have a known corrosion issue that has caused all sorts of problems. I know of two people who have done rebuilds in the past year... one with 225's and one with 250's.
Im not sure where you are but the guy I would talk to, regardless of where you are, is Chris Burleson of Burleson Marine in Morehead. He is, hands down, the best Yamaha mechanic in the area and is straight forward and honest.
His motor is a a two stroke if it is a 99. I think you are talking about the 2002 -05 four strokes for the corrosion issues.
There is a place in Pa to stay away from for rebuilt powerheads online. They keep changing there name because of there bad rep. I would do a whole rebuild if you plan on keeping it.
If you are having a dealer/repair shop do it, they will probably get a re-built P/H or send your's out to be done. If you were doing it yourself, I'd recommend Coastal Performance Marine in Rocky Point. Jimmy has one of my 200HPDI P/H's now. I dropped it off Mon and it'll be ready Fri. He's done about 5 or 6 OX-66's for me in the past. He tears them down, lets you know what is wrong, and you decide whether to repair the problem or do a full rebuild.