SWC Forums
Pull up a chair...let's talk fishing.
Started motor after 2 month layoff with muffs on before going out. Good thing because no pee flow and thermostat flow never kicked in. Replace water pp impeller; housing had a good bit of melting so I replaced deverything. Still no cooling flow and got hi temp alarm. Removed thermostats; not great but they don't look that bad. Will replace them. Not sure if this is the right test or not but I hooked up the muffs to see if I could get flow out the open thermostat housings. None Ran the motor with thermostat housing off..no flow out housing or pee hole. So;
1. any thoughts on what to do next
2. I'm not sure if blockage is my problem but what is the proper way to test all portions of the cooling system to ensure I have no blockage anywhere?
I'm not sure about the F225, but the F115 I had came with a direct-connect for a water hose on the back side of the engine near the steering arm. I never had any luck with muffs on that engine and the direct-connect could be done without running the engine as well.
Depending on the year of you motor, this may be an option?
I had same problem with my 225 a couple years ago. One time mud daubers had clogged up the pee hole. Small piece of wire fixed that. Then another time the pee stream was very very weak. After replacing impeller, I had my mechanic replace water pump. Try wire and see if that produces any results.
Knight, That connection is just for flushing, my problem in no cooling flow. Understood that the muffs can be iffy but I also ran the motor in a tub of water..no flow at all.
Salty..don't think its the pee hole as I have no cooling flow at all.
I go with mud daubers they are tenacious little bastards and will go a long way to plug a hole. If you have done all that work then you have a blockage.
It's looking like some kind of blockage somewhere. Took the foot of, pump housing overheated again. There's a lesson, it doesn't take long. The alarm hadn't sounded 2 seconds before I turned the engine off. With little or no flow, I'm guessing damage to the housing occurs even before alarm is recieved. Anyway with thermostat housings off, foot off, flush line off and directing hose in water pump discharge line (engine uptake) I get no water out of the thermostat housings or out of the flush line. Looks like all the water is going out what I assume are cooling channels around the exhaust. Flushing from the flush connection I get a good bit of flow out the thermostat housings (engine side) as long as I keep the water pump discharge line plugged. (Without plugging all the flow goes out the line). So I guess I'm onto my second question above; I need to map out the cooling system flow paths and come up with proper way of clearing/flushing the various flowpaths. aarrgghh! side note.. I'm still getting no flow out of the pee line by flushing either way. The line is clear all the way to where it connects on the front port side of engine (ran stranded leader all the way). There's another line coming off the same block the pee line connects to that runs around and in the back of the engine. Disconnected it and got solid flow
Does it have popit valves at the bottom of the heads? If so, what would happen if they were stuck closed?
good question, got to look into that. I don't have a shop manual so not even sure where they would be