SWC Forums

Pull up a chair...let's talk fishing.

Battery Installatio...
 
Notifications
Clear all

Battery Installation Question

4 Posts
3 Users
0 Reactions
17 K Views
Jeff Naylor
(@)
Trusted Member
Joined: 14 years ago
Posts: 35
Topic starter   [#45049]

I have a 16 foot Polar Kraft boat that I use for flounder gigging and duck hunting. I have LED lights for gigging so I don't run a generator. I have two batteries installed. Battery #1 is for cranking, nav. lights, GPS, bilge pump, etc.
Battery # 2 runs the trolling motor and the gigging lights. The gigging lights I have can not be hooked to a charging battery when they are running. I would like to hook the two batteries together with a switch so i could turn the switch on when running under power so both batteries will charge and they turn the switch off to disconnect the two batteries to run the gigging lights. I can't add a third battery due to lack of space.

1. Could it be done?
2. Should it be done?
3. If so should they be hood up in Series or Parallel

Any thoughts or suggestions would be good.
My wife's answer is "Leave it alone, when the battery dies it time to come home".



   
Quote
Darrell  Garrett
(@)
Honorable Member
Joined: 19 years ago
Posts: 569
 

When you purchase the switch it will have the following , battery one, battery two , both batteries and off ... Never connect in series because you will get 24 volts ....



   
ReplyQuote
jerry leonard
(@jerryd)
Estimable Member
Joined: 19 years ago
Posts: 116
 

Without an isolator if you have both batteries on line the first one to reach full charge will stop the charging process.



   
ReplyQuote
Jeff Naylor
(@)
Trusted Member
Joined: 14 years ago
Posts: 35
Topic starter  

Thanks for the responses. I did a little research on isolators. It appears that the isolator will cause a voltage drop and not allow the battery to be fully charged in some cases so that may not be the way to go.



   
ReplyQuote
Share: