SWC Forums

Pull up a chair...let's talk fishing.

Braid to Mono conne...
 
Notifications
Clear all

Braid to Mono connection for spinning/casting

25 Posts
18 Users
0 Reactions
62.8 K Views
seaho
(@seaho)
Eminent Member
Joined: 18 years ago
Posts: 22
 

It is a little complex to start with, but the ultimate is using a hollow core braid sleeve. The braid( main or tag line) goes in one end, the leader goes in the other. You should serve the ends, but smooth, 100% connection with no knots in the braid or leader. Only requires 10 ft or so of hollow braid for sleeve.



   
ReplyQuote
Toby
 Toby
(@)
Estimable Member
Joined: 20 years ago
Posts: 156
 

PR knot



   
ReplyQuote
harry smith
(@)
Trusted Member
Joined: 16 years ago
Posts: 37
Topic starter  

Was trying to avoid using gloves while casting, holding onto the braid while casting will slice fingers. Seems most folks cast with the braid/mono connection past the top ring. Guess I will invest in gloves, thank you to all



   
ReplyQuote
Josh Benton
(@)
Noble Member
Joined: 14 years ago
Posts: 841
 

I braid on all of my spinning gear most of it being for inshore fishing and to A LOT of casting for trout and reds and I've never had an issue with the braid even hurting my finger much less cut my finger.



   
ReplyQuote
Jordan
(@)
Estimable Member
Joined: 15 years ago
Posts: 126
 

Nope, only time I have been cut with braid was when putting tension on the line with wet hands and such. Never happened to me casting. If you are having trouble with it cutting your index finger, maybe you could put a piece of tape on the end of your finger? Gloves just for casting seems overkill.



   
ReplyQuote
Sea Cern
(@)
Estimable Member
Joined: 13 years ago
Posts: 172
 

Uni to Uni for the small stuff. Spider Hitch to double the braid and a Slim Beauty for big mono shock leaders.



   
ReplyQuote
icecreamman
(@)
Noble Member
Joined: 21 years ago
Posts: 2017
 

CoolBlue , what type of fishing & braid poundage are you planning to use? ..... ICM



   
ReplyQuote
Drew Maultsby
(@)
Prominent Member
Joined: 17 years ago
Posts: 806
 

The only reason for braid to slice a finger when casting a spinning rod is that the drag is too loose. As you load the rod just prior to release, the braid will slip through your finger at the point when the load on the rod tip is greater than the resistance of the drag and your finger. If you loosen your drag while fighting a fish, and forget to readjust for the next cast, ouch!!
Can be especially dangerous casting heavy sinkers while surf fishing, and a glove may not save your finger.



   
ReplyQuote
carl cliver
(@)
Eminent Member
Joined: 17 years ago
Posts: 30
 

go to you tube and look up the red phillips knots you will love it



   
ReplyQuote
Drew Smedley
(@dfs5)
Estimable Member
Joined: 15 years ago
Posts: 99
 

Red Phillips knot.

x2



   
ReplyQuote
Page 2 / 2
Share: