SWC Forums
Pull up a chair...let's talk fishing.
Cracking in FRP (Fiberglass Reinforced Plastic) can only happen for 4 reasons.
Unreinforced, excessively thick resin, including the gelcoat.
Movement (mechanical or thermal)
Strand Orientation
Resin Mixing (mis-mixing)
Think of the fiberglass like rebar in concrete. They both do the same thing - dissipate the shrinkage stress of the cement or resin and add considerable tensile and flexural strength. Without rebar or other reinforcement, concrete will crack when it cures. Without glass fibers in resin, it too will shrink and crack.
Look at the cracks in the gelcoat under 50X magnification. Are they somewhat parallel even if they curve and can you see the bottom? If you can, it's a cosmetic issue due to a thick area of unreinforced gelcoat. Have it fixed and it won't recur because the shrink stress has been relieved. If the crack extends into the glass filaments and some of them are broken you have a member that it flexing past the elastic limit of the composite and you have a potentially serious problem. It's a design issue that needs immediate attention. If the cracks are deep and you can't see any glass, the layup might have been wrong (doubtful but possible) and it will require professional attention and should be something a manufacturer WANTS TO FIX. Last, if the cracks look like shattered glass, have no pattern and are in "patches" in corners and on flat, smooth areas, the resin mix was wrong and again it's a cosmetic issue. once repaired it's gone for good.
Polyester and Vinyl Ester resins are pretty simple chemistries that are now so widely used and the fiber reinforcing systems so well understood that it is highly doubtful it is a structural issue. 95+% of the problems are human error and probably half of those happen when the gelcoat is applied to the mold. It just gets sprayed on a little too thick in a few spots. Since gelcoats are pure resin, applying them just slightly too thick can result in cosmetic, surface shrink cracking.
Hope that helps.
I had an Onslow Bay for 7 years of Bluewater and King Tournament fishing. She took on some tough seas over the years, with over 900 hrs. on engines. We never had any cracks in her. The only reason I sold her was to deploy overseas and get a new one when I return home to NC. Just my experience in an OB and my two cents.
Wouldn't expect any less from an Onslow Bay, one of the best built boats in the industry!
Also, thank you for your service to this country!!