SWC Forums

Pull up a chair...let's talk fishing.

Notifications
Clear all

outriggers

9 Posts
7 Users
0 Reactions
17.6 K Views
travis
(@)
Trusted Member
Joined: 15 years ago
Posts: 51
Topic starter   [#39642]

I just purchased a boat that came with 18ft taco outriggers not yet rigged. Would it be better to secure them to the gunnels or to the ttop? The holders are already installed on the ttop.also is there a diagram out there that helps with the rigging?

Thanks



   
Quote
Jamie Blue
(@)
Famed Member
Joined: 20 years ago
Posts: 3660
 

T Top definitely. Go to George Poveromo's website for the rigging, lots of people like that way.

I just use hallocks, it's simpler.



   
ReplyQuote
Mike
 Mike
(@baytro23)
Honorable Member
Joined: 18 years ago
Posts: 681
 

Most center consoles I've seen secure the halyard/pully to the gunnels. Much easier to clip the lines in at waist level than above your head on a rocking boat.



   
ReplyQuote
Duane
(@rdnkvet)
Noble Member
Joined: 16 years ago
Posts: 1403
 

The advantage of having halyards attached to t-top is the lines are up allowing angler to move towards bow to chase fish or allow room for leadering/gaffing fish. The disadvantage is the lines are harder to reach for shorter people, so mounting to gunnel may be better for some. You could set them to attach further down t-top supports if height is an issue. Here is recent good info on topic.

http://fryingpantower.com/ftopict-39804-Outriggers.html



   
ReplyQuote
Mark
 Mark
(@)
Eminent Member
Joined: 19 years ago
Posts: 21
 

The advantage of having halyards attached to t-top is the lines are up allowing angler to move towards bow to chase fish or allow room for leadering/gaffing fish. The disadvantage is the lines are harder to reach for shorter people, so mounting to gunnel may be better for some. You could set them to attach further down t-top supports if height is an issue. Here is recent good info on topic.

http://fryingpantower.com/ftopict-39804-Outriggers.html

Did you end up using the Cam Jam's you mentioned in the other thread? I have a couple that I purchased for attaching my halyard to an existing loop on the gunnel. Re- Rigged one outrigger yesterday and have to get the other one done early this week but initially I have it rigged with a tautline hitch.

might consider using Box's method eventually with the Fid and some rope work but not ready for that right now.



   
ReplyQuote
Duane
(@rdnkvet)
Noble Member
Joined: 16 years ago
Posts: 1403
 

I did not use cam jams. I used Box's halyard method and just tie off to aluminum frame under the t-top.



   
ReplyQuote
William McCann
(@werewolf0711)
Famed Member
Joined: 15 years ago
Posts: 3133
 

I go for the ttop. I want to have easy access all around my boat. I've tried both ways and prefer it on my ttop the best.

I have went with boxes halyard method since this picture. It's very easy to reach. Even for the shorter people. With my rigging the release comes in the boat where's on the gunnel you have to lean over just a bit.



   
ReplyQuote
warren barton
(@rockhound)
Noble Member
Joined: 19 years ago
Posts: 946
 

The advantage of having halyards attached to t-top is the lines are up allowing angler to move towards bow to chase fish or allow room for leadering/gaffing fish. The disadvantage is the lines are harder to reach for shorter people, so mounting to gunnel may be better for some. You could set them to attach further down t-top supports if height is an issue. Here is recent good info on topic.

http://fryingpantower.com/ftopict-39804-Outriggers.html

Just keep the snaps unlocked and remove when you need to move up.I like them easily reachable.



   
ReplyQuote
Jamie Blue
(@)
Famed Member
Joined: 20 years ago
Posts: 3660
 

Another vote for t-top. I'm tall so it's no problem reaching them and still get 360 degree fish ability.



   
ReplyQuote
Share: