SWC Forums
Pull up a chair...let's talk fishing.
My question is what brought the dealer to the conclusion that something structural is broken loose. Just because the ttop screws or bolts are loose doesn't mean something is broke. Do you realize how much vibration and stress is put on that stuff.
Also, just because there is gel coat issues doesn't mean something is broken either. Every boat has those and some worse than others. Without you providing pictures of the problem your inquiring this is really a useless thread.
I think in the end the FACTORY will do what is needed to correct the problem. Be sure to keep any documents from this you can so if needed for down the road.
Soft spots in the floor, where the soft spot ends a large section of cracks begin that are over two foot long. With all screws tightened down the T-Top sways very badly. The dealer said in all of his years of business he hasn't seen a T-Top do like this one. I beg to differ about it being a useless thread, I was attempting to reach other TW owners to see if they are having problems. Tidewater Boat Owners Forum has quite a few and as someone stated above- they have seen this issue in other forums. We all know what they say about opinions though......
Seems like tidewater is running through some problems in their newer boats, late 2013 and up. I previously owned a 2012 Tidewater 250cc that was like a tank. I now own a 2015 250cc and have found no real issues yet but really haven't had the boat out in much water yet. This is being talked about on a lot of forums right now and is very disturbing. Almost makes me want to not even use the boat.
My question is how much emphasis have they put into this 280cc boat? Have they forgotten about the smaller boats that built their brand. Will update later when check out my new boat.
Not trying to pick a fight here but your old boat was like a tank and you have no real problems with your new boat (yet), but your disturbed because some guy on the HT posted about 20 ranting pages of the same 3 minor issues. One of which is clearly identified as an issue by the Manufacturer and had remedial actions in place.
I saw a separate posting where Mr. Bi-Polar himself posted that it was the best boat he ever had and recommended that buyers pursue Tidewater boats over all other. Go figure.
Believe what is beneath your feet not what drama queens write.
Sorry if I offended.
Many two piece hulls have to have a reinforcing plate
glassed to underside of floor. If you have an aftermarket t-top,
maybe installer missed this plate (s).
At any rate, screws are a poor way to attach items to
a sheet of fiberglass backed w/foam.
Try to contact them on facebook.
I commented on one of their post about the Tidewater's Live Well system and someone responded pretty quick. I don't think it was just a marketing person.
If that doesn't work, I would take it straight to Gore Marine off 421. He will be a great person for a non bias opinion. Especially dealing with a broken T-Top.
That sucks to have an issue like that, good luck.
My pops got a 2014 1900 Bay Max. Gelcoat cracks started at the T-top legs and spread from there. The dealer contacted the factory and a fiberglass guy "fixed it", a month later and the cracks were back. They've actually spread throughout the entire top cap now while it's waiting for a truck to go back to the factory. He ain't real happy either but seems like his dealer and tidewater is making a good effort to remedy the problem. Apparently they had a bad batch of boats lately this is definitely a problem they're aware of. He's still using it while he waits, he's been assured by the factory that cracks are cosmetic and the T-top won't fall off, so far so good...
Seems like tidewater is running through some problems in their newer boats, late 2013 and up. I previously owned a 2012 Tidewater 250cc that was like a tank. I now own a 2015 250cc and have found no real issues yet but really haven't had the boat out in much water yet. This is being talked about on a lot of forums right now and is very disturbing. Almost makes me want to not even use the boat.
My question is how much emphasis have they put into this 280cc boat? Have they forgotten about the smaller boats that built their brand. Will update later when check out my new boat.
Not trying to pick a fight here but your old boat was like a tank and you have no real problems with your new boat (yet), but your disturbed because some guy on the HT posted about 20 ranting pages of the same 3 minor issues. One of which is clearly identified as an issue by the Manufacturer and had remedial actions in place.
I saw a separate posting where Mr. Bi-Polar himself posted that it was the best boat he ever had and recommended that buyers pursue Tidewater boats over all other. Go figure.
Believe what is beneath your feet not what drama queens write.
Sorry if I offended.
Not trying to pick a fight with you either. I have spoken to just about every owner of a newer model 250cc and each one has reported the same problems with the boat. The gel coat and stress crack problems are not isolated to Geo. Many more of these problems appearing. Read some of the posts on tidewaterowners.com DIY.
The side of my 2012 hull felt like a regulators side and the side of my 2015 feels much more flexible. Not sure if that is an issue or not just something I noticed. Actually spoke to the factory about it and Tim the engineer asked me to monitor it when I take it out as the foam gun may not have pumped enough foam into hull. Also have noted that the hatches in my floor are much less rigid then previous boat.
I have no doubt that Tidewater will address any of the issues that occur with the boat. Just sounds like they are going to have plenty of warranty work to take care of in near future.
Update: I've been working 13-14 hour days for the past few weeks and haven't been able to give an update here. I called TW last Friday to check the status and nobody could tell me anything, the lady couldn't even tell me if my boat was on their site so I was royally pi$$ed the whole weekend. On Monday I called and spoke with the new warranty/parts guy (very nice kid with a lot thrown on him at once). The previous parts guy Andy was no longer employed there, when I heard that my heart sank. I just knew he had lied to me, 8-10 days seemed to good to be true. Anyway, the new parts guy told me they had not started on my boat and I really flipped my lid. It was the 6th business day and my boat hadn't been touched.A gentleman from another forum told me to speak with Jai. It took a little while but I finally got him on the phone and briefly described what was going on then sent him an email with a time line of events (very detailed and a few pages long) along with a link to the Hull Truth thread I had and at that time had around 2,000 views. He called me back and said he had read some but not all and thanked me for showing him the link as well, said he had to go do something for his child and when he returned he would finish reading and call me back. When he called back he informed the parts guy had misspoke and work was well underway on my boat. He said they shouldn't have a problem meeting the original deadline promised. He also said he would be contacting me everyday with an update. So far the man has kept his word to a "T". They have upgraded my T-Top to the new slimmer one along with a new frame. He said I did have some serious issues but they have been taken care of. He is an all around great guy that understands customer service and understands that even a 23' is a major investment to people like myself. He just called me a few minutes ago to tell me they were not shipping the boat out today, he wanted it cleaned well before it left and he was also excited about some other things they done to the boat but he didn't want to tell me, he wanted me to see it and then we would discuss. I honestly wish I could have spoken to this man instead of Andy from the beginning and there wouldn't be negative post from me about TW. I just wanted communication, game plan and a time frame, which I received all of these from Jai. I will update again when I pick the boat up Monday/Tuesday. Hope everyone has a great Easter weekend.
Glad to hear it. When my boat was new in 07, I had a spot I didn't like. They took the boat back and returned it with a new tilt steering helm. At the time I bought mine they didn't offer it so they upgraded it for free.
Picked the boat up today. Jimmy had to have his parents deliver it to the dealer. They had it back a day earlier than the due date and it had a brand new T-Top on it. I was inspecting the previously damaged areas and everything was looking good until I looked in the port side fish box. It had more cracks in it today than when it left. I'm done with it, I sent Jai an email along with pictures and let him know how I felt (very nicely). The ball is back in their court. I believe there are major problems with this hull and it disappoints me to no end......
Could you let me know if they ever fixed your boat. I believe my stringers have come loose the bottom of my boat has stress cracks and seems the floor has soft spots screws coming loose everywhere. my last trip I had visions of the t-top flying off. Mike Moore 910-524-4910