SWC Forums
Pull up a chair...let's talk fishing.
The original tank was 80 gallons. We shaved the sides off a little to slide it forward. Might be in the 75 range now.
The beam of the stern is exactly 96". Makes sense, because it's made of marine plywood. It gets about 102" a little past midship. Never measured the dead rise or weight.
Cool man. I will bet it's 24* deadrise just from the pictures. She looks to have a very sharp entry. That will be nice especially with that chine and flare to knock spray down. I bet that boat performs real good. Definitely built for the NC water.
I'll post some more pics tomorrow.
Stuart,
Great story and hope she lives for a very long time!!!
Enjoy
Cool man. I will bet it's 24* deadrise just from the pictures. She looks to have a very sharp entry. That will be nice especially with that chine and flare to knock spray down. I bet that boat performs real good. Definitely built for the NC water.
Looks like about 8* at the stern.
Gonna be some fine memories made in her cockpit!!!!!
Great story and beautiful boat!
I don't know how many of those are around but I passed a bc cc today heading east on 40 near garner. Looked like yours. Looked 23'-25' with twin four stroke zukes on the transome
I don't know how many of those are around but I passed a bc cc today heading east on 40 near garner. Looked like yours. Looked 23'-25' with twin four stroke zukes on the transome
Definitely not my boat, it's still on stands.
After we coated the bilge we cut out the floor. We used 1/2" marine grade plywood. We temporarily screwed the floor down with washers while the epoxy to the stringers dried. After that, we countersunk every hole and came back with stainless flat-head screws. Those holes were then epoxied over to give a smooth finish.

Good welders = Artists. Keep the pics coming!
Definitely not my boat, it's still on stands.
Yea man no doubt about that, it just looked like yours did in the first pictures you posted. I have only seen a handful of those bc center console boats under 25' and I thought it was funny to see one about the time you started posting on this again. Beautiful boats. Looks like y'all are getting on it pretty good, keep the updates coming!
Trying to keep these photos coming, but I keep getting distracted...
Next we laid a layer of fiberglass to the deck and installed scuppers. Before the boat wasn't set up to be self-bailing. This was a new addition.
We then framed up the new bulkhead and cut out the holes for the tackle storage. Only the starboard sides are actually storage. On the port side we ran the fish box all the way to the floor. The port side box stops right above the storage which will be used for drinks / snacks.



