SWC Forums
Pull up a chair...let's talk fishing.
Nice work! Post back when you get some performance numbers.
That's a pretty boat! You really got on that with a quickness. I'm a little disappointed I wasn't invited to the launch :shrug:
Looking forward to hearing the performance numbers and how it rides.
That's one sweet ride right there!!!
Congrats Stuart, very nice ride!!!
Man, that is a beautiful sled! Nice work.
Nice ride
Absolute work of art, you should be very proud! :wtg:
I fish out of MHC but may have to venture south just to put eyes on her, beautiful job!
be sure you keep that boat under lock and key, fellow on another site did a ground up on a 26' Stamas, thieves stole it and he got a stripped out hull back.
Awesome!!!!!!
The boat has been a lot of fun. I've had a chance to fish, spearfish, and cruise around the waterway. I had paid some folks to replace the transom the 1st go-round and was really disappointed with their work. We knew it was a matter of time before the home depot plywood would rot out.
That day came in August of 2017 and I decided to undergo a project that would leave Country Gal on the hill for an entire year. I started the project by cutting out the old transom. I had made good progress in the beginning, but got distracted along the way.
The project would have been quick and easy if I had not decided to extend the boat at the same time. While the transom was open, I extended off the back an additional 18". This extension converted my 22' Buddy Cannady into an 24' Buddy Cannady.
A lot have people have called and written emails since the original post and throughout the progress on this thread. Some folks have BC boats of their own, some are looking to purchase, and others were building wooden boats from scratch. I hope these photos will continue to help with motivation towards your wooden boat or someone you know's wooden boat.
During this project, we had lost my grandfather (Pop Pop) at the age of 86. My cousins Aaron Croswait, Jordy Croswait, and uncle Bobby Croswait wanted to help preserve the Country Gal. They asked that when I complete the construction of the transom/fish box, to haul her to Wanchese, NC where they would complete the sanding and paint.
Please enjoy the photos and please continue to email or call if you have any questions or if you need help getting your project off the ground.
We had actually started this project by removing the motor bracket so I could build a bigger bracket with more buoyancy. I had figured with the extra cubic footage in the water, the new bracket would allow for 130 pounds of lift. This would allow for the back end of the boat to float higher and trim better (even with the upgrade to a Yamaha 250).
While the bracket was off, I could feel the moisture in the transom. I started to cut.. little did I know, that I would have to take off the entire transom and rebuild it.


While at the point of no return is when someone had told me about the opportunity for extension. I had not even thought about it, but decided to go through with it.
I started by clearing out all of the old/rotten wood. Once I had a clean surface, I started framing up the extension. We used some juniper wood that my dad had given to me a while back and the rest built with marine grade plywood. All of the epoxy used was West System.


With the 3/4 plywood extension frames in place, I then came up from the bottom with 3/4 plywood. I held things in place with clamps while the glue and fillets dried. A 3/4 plywood top plate was added to help patch things together. I put some relief strips in the top plates to help them curve to the bottom.









