SWC Forums

Pull up a chair...let's talk fishing.

Stuart Foreman
Stuart Foreman
@highspeedwelding
Estimable Member
Joined: Aug 8, 2009
Topics: 19 / Replies: 128
Reply

Here's a photo of the bottom side of the fish box lids. Insulated them with a few layers of 1/2". The 150 Yamaha was hung as well.

11 years ago
Forum
Reply

While the primer was drying, I climbed underneath the boat and put on a fresh coat of bottom paint. In one of the photos you can see the keel that wa...

12 years ago
Forum
Reply

After all of the hardware was removed, we went ahead and put on a coat of epoxy primer.

12 years ago
Forum
Reply

I also found a little spot on the bottom that needed some more glass. Sanded it down and put on a new layer.

12 years ago
Forum
Reply

Here is a photo with the primer.

12 years ago
Forum
Reply

Around this point I was starting to prep everything for paint. When removing the cleats in the bow, I found a good amount of rot. Rather than painti...

12 years ago
Forum
Reply

From there we added the console. The T Top was built by accident a couple months before I bought the boat. I didn't yet have a console for it, so I ...

12 years ago
Forum
Reply

Trying to keep these photos coming, but I keep getting distracted... Next we laid a layer of fiberglass to the deck and installed scuppers. Before...

12 years ago
Forum
Reply

After we coated the bilge we cut out the floor. We used 1/2" marine grade plywood. We temporarily screwed the floor down with washers while the...

12 years ago
Forum
Reply

Here is a picture with the bilge finished out with paint, fuel tank, and rigging tube. The bilge has one layer of fiberglass. We then sanded it and ...

12 years ago
Forum
Reply

Definitely not my boat, it's still on stands.

12 years ago
Forum
Reply

I'll post some more pics tomorrow.

12 years ago
Forum
Reply

The original tank was 80 gallons. We shaved the sides off a little to slide it forward. Might be in the 75 range now. The beam of the stern is exac...

12 years ago
Forum
Reply

From here you can see how we framed up around the fuel tank. We also modified the tank so it could slide it forward 8". The boat sat a little h...

12 years ago
Forum
Reply

At some point during the build, I lost my phone. There are a lot of photos missing of the fiberglass that was laid in the bilge. The first photo is ...

12 years ago
Forum
Page 3 / 10